How To Attach the ProCut Strap On Swing Weights
Loop the two crossed wires over the end of the bat handle as shown in the picture on the right.
Using one hand to hold the two wires in place, turn the knob of the ProCut clockwise with the
other hand as much as possible until it is securely attached to your bat.
|
 |
How To Attach the ProCut Screw On Swing Weights
Insert screw into knob of bat, turn right until securely tightend. Turn left to remove the weight.
|
|
Replacing the ProCut Weight
The Pro Cut weight is made to be removed. Should it come off
during use, follow these simple steps to replace it.
1. Have the base (part with wires) at least half way up the screw
towards the knob.
2. Hold the weight firmly in one hand.
3. Hold the knob firmly in the other hand.
4. Insert the threaded centering post in the weight at an angle,
so that one edge of the tapered leading edge fits under the
o-ring in the center of the weight.
5. Press and twist the weight towards the knob so that the tapered
leading edge of the centering post slips into place beneath the o-ring.
NOTE: The weight should spin freely on the centering post for proper installation.
|
 |
Safety First!
Always make sure your ProCut is securely fastened to your bat before you begin swinging.
Swing in a safe place during use and make sure you fully tighten the unit frequently to be
sure that it will not come loose.
Maintenance:
Be sure to lubricate the screw once a month.
ProCut fits most aluminum and wood bats. Different size wires are available for other bats. If
ProCut does not fit your bat or if you have any other procut questions, please email tim@procut.com.
|
